CONNECT ETHERNET CABLE
CONNECT ONE ANALYZER
1. Plug one end of the Ethernet cable into the Ethernet port on the analyzer.
2. Plug the other end of the Ethernet cable into the Ethernet port on the computer.
CONNECT MULTIPLE ANALYZERS WITH AN ETHERNET SWITCH
An Ethernet switch is required to connect:
n Multiple analyzers
n One or more analyzers and one computer
n One or more analyzers, one computer, and one or more Smart VacPrep units
To establish the connection:
1. Connect the power cord of the Ethernet switch to an appropriate power outlet.
2. For each analyzer, connect an Ethernet cable from the Ethernet port of each analyzer to a
numbered port on the Ethernet switch taking care not to use the uplink port on the switch.
3. Use an Ethernet cable to connect the computer to the Ethernet switch. Do not use the uplink
port.
4. Ensure the computer and the Ethernet switch are powered on.
Do not use the uplink port when using an Ethernet switch.
Connect Ethernet Cable
Gemini VII 2390 Installation Instructions and Checklist
239-42870-02 Rev (B) — May 2021
2 - 3
To Next Page
Loading...
