Micromeritics GEMINI VII 2390 - Page 102

9 Installation Checklists
Procedure
Evaluation
Code
Initial / Date
Connect the power cord to the analyzer and power source. P F N/A
If one Ethernet based analyzer was purchased, connect the
Ethernet cable to the analyzer and the computer, or if more
than one Ethernet based analyzer was purchased, connect an
Ethernet cable from the computer to the Ethernet switch. Then
connect the Ethernet based analyzers to the Ethernet switch.
P F N/A
Connect Cables
Procedure
Evaluation
Code
Initial / Date
Optional Smart VacPrep installed.
P F N/A
Degasser Installation
9 - 4
Gemini VII 2390 Installation Instructions and Checklist
239-42870-02 Rev (B) — May 2021