Adsorptive Line Test 3 - 16
Helium Line Test 3 - 18
4 Software Installation 4 - 1
Start the Application 4 - 9
5 Analyzer Preparation 5 - 1
Unit Configuration 5 - 1
Unit Selection 5 - 1
6 Gas Connections 6 - 1
Guidelines for Connecting Gases 6 - 1
Connect a Regulator and a Gas Line to a Gas Cylinder 6 - 3
Connect Gas to Analyzer 6 - 5
Clean and Verify the Gas Line 6 - 6
7 Operational Verification 7 - 1
Measure Saturation Pressure 7 - 2
Perform a Reference Material Analysis 7 - 3
Clean and Label Sample Tubes 7 - 5
Create Sample Files 7 - 8
Determine the Sample Mass 7 - 10
Degas Samples 7 - 11
Sample Tube Installation 7 - 12
Dewar Precautions 7 - 14
Fill and Install the Dewar 7 - 15
8 21CFR11 Environments 8 - 1
Overview 8 - 1
User Permissions 8 - 2
Software Installation in 21CFR11 Environments 8 - 5
Uninstall Software in 21CFR11 Environments 8 - 15
Maintaining Confirm Users and Groups 8 - 16
Gemini VII 2390 Installation Instructions and Checklist
239-42870-02 Rev (B) — May 2021
x
To Next Page
Loading...
