4 Software Installation
4. On the Ethernet Introduction window, verify that all prerequisites have been met.
a. If not, click Cancel and complete the steps, then restart the installation program. Do
not proceed with installation until these tasks have been completed.
b. If the prerequisites have been met, click Next.
5. On the Choose Users window, select either of the following, then click Next:
n Install for anyone using this computer. Anyone who logs on to this computer will have
access to the analyzer program.
n Install just for me. Only the person logged on to the computer at the time of installation
will have access to the analyzer program.
4 - 2
Gemini VII 2390 Installation Instructions and Checklist
239-42870-02 Rev (B) — May 2021
To Next Page
Loading...
