a. In the Step 1 group box:
If...
Then...
installing the analysis program dur-
ing initial installation
select the number of analyzers to be
installed.
using the analysis program for off-
line data reduction
select 0.
moving an analyzer from another
computer to this computer
select 0.
b. In the Step 2 group box, enter the serial number for each analyzer to be
attached to this computer. The serial number label is located either near the
incoming power supply or near the ON/OFFswitch.
c. Click Next.
10. On the Ethernet Ports window, select one option from the following table:
If...
Then...
the configured port is listed
select the port, then click Next.
the configured port is not listed
click Specify and enter the remaining portion of the
IPAddress, then click Next.
The IP Address must be 192.168.77.100.
4 Software Installation
Gemini VII 2390 Installation Instructions and Checklist
239-42870-02 Rev (B) — May 2021
4 - 5
To Next Page
Loading...
