13. If installing a SmartPrep at this time, enter the number of SmartPreps being installed, then
select the communication port connected to the first SmartPrep. Click Next.
14. If installing a Smart VacPrep at this time, enter the serial number of up to four Smart
VacPreps on the Configure the Smart VacPreps window, then click Next. If not installing a
Smart VacPrep, click Next. A Smart VacPrep can also be installed after the analyzer soft-
ware installation is complete.
4 Software Installation
Gemini VII 2390 Installation Instructions and Checklist
239-42870-02 Rev (B) — May 2021
4 - 7
To Next Page
Loading...
