8 21CFR11 Environments
10. When installation completes, the Installed window displays. Click Next.
11. The Analyzer Configuration window is used to configure the system for each analyzer and
serial number to be installed.
a. In the Step 1 group box:
If...
Then...
installing the analysis program dur-
ing initial installation
select the number of analyzers to be
installed.
using the analysis program for off-
line data reduction
select 0.
moving an analyzer from another
computer to this computer
select 0.
b. In the Step 2 group box, enter the serial number for each analyzer to be attached to
this computer. The serial number label is located either near the incoming power
supply or near the ON/OFFswitch.
c. Click Next.
8 - 10
Gemini VII 2390 Installation Instructions and Checklist
239-42870-02 Rev (B) — May 2021
To Next Page
Loading...
