7 Troubleshooting and Maintenance
POWER INSTRUMENT ON AND OFF
To power off the instrument, disconnect the power cable.
It is recommended that the instrument remain powered on. When the main power is
disconnected, the piston loses the home position and will need to be reset. See Home
Position on page5 - 3.
Power ON the equipment in the following order:
1. Plug in the instrument. (There is no ON/OFF power switch.)
2. Allow the instrument to run for approximately 60 minutes.
Power OFF the equipment in the following order:
1. Ensure the instrument status is Idle.
2. Disconnect the power plug from the instrument. (There is no ON/OFF power switch.)
7 - 8
MIC SAS II 5800 Operator Manual
580-42800-01 (Rev - ) — June 2019