5 INSTRUMENT MENU SELECTION
Use for manual operation and monitoring the state of the instrument.
Additional controls are present when Allow calibration is selected in the Maintenance
>Advanced view. Changing calibrations can affect the performance of the instrument.
Make changes only under the direction of a Micromeritics Service Representative.
Component
Description
Anvil
Anvil with O-ring inside sample tube. Abrass plug with filter paper is
placed between the sample material and the anvil.
Piston
Piston with O-ring inside sample tube. Abrass plug with filter paper is
placed between the sample material and the piston.
Sample tube
Steel, open-ended sample tube.
Instrument Schematic
5 Instrument Menu Selection
MIC SAS II 5800 Operator Manual
580-42800-01 (Rev - ) — June 2019
5 - 1
To Next Page
Loading...
