Specifications
AVERTISSEMENT : Microsemi recommande que le châssis soit relié à une terre fiable.
Note: To connect a ground to the chassis, use a 3/8" 10-32 screw.
WARNING:VDCPower
For the 48 VDC model of the SyncServer:
n Use a disconnect device, such as a switch, with the appropriate voltage/current rating
when connecting a VDC Power source.
n Only use the unit in an restricted area.
n The screw torque on the Power Terminal Block is 4.5 to 5.3 inch pounds.
n The unit chassis must be grounded for proper safety.
AVERTISSEMENT :
Sur le 48 VDC modèle du SyncServer:
n Utilisez un dispositif de débranchement, tel qu'un commutateur, avec le classement de
tension/courant approprié en connectant une source de pouvoir de DC.
n Employez seulement l'unité dans un secteur avec l'accès limité.
n Le couple de vis sur le TB de puissance est livres de 4.5 à 5.3 pouces.
n Le châssis d'unité doit être fondu pour la sûreté appropriée
WARNING:GPSAntenna
n Avoid electrocution and RF safety hazards such as power lines and high-energy radio
transmission antennas.
n Where potential hazards exist, have a qualified technician perform the installation.
n Observe local codes and regulations.
n Use a lightning arrestor when needed.
n Antennas not rated for 12 VDC may be damaged when connected to the SyncServer.
The GPS antenna supplied with the SyncServer is rated for 12 VDC.
n
Safe Antenna and Cable Connection: An outside antenna or cable system must be properly
grounded to provide some protection against built up static charges and voltage. Section
810 of the National Electrical Code, ANSI/NFPA 70 (In Canada, part 1 of the Canadian
Electrical Code) provides information regarding proper grounding of the mast and sup-
porting structure, grounding of the lead-in wire to an antenna discharge unit, size of
grounding conductors, location of antenna discharge unit, connection to grounding elec-
trodes, and requirements for the grounding electrode.
n
Keep Antenna Clear of High Voltage Power Lines or Circuits: Locate an outside antenna sys-
tem well away from power lines and electric light or power circuits so it will never touch
these power sources should it ever fail. When installing an antenna, absolutely never
touch power lines, circuits, or other power sources, as this could be fatal.
AVERTISSEMENT :
n Evitez et les dangers de sûreté électriques et RF, tels que les lignes à haute tension et les
antennes de transmission de radio de haute énergie.
n Où les dangers potentiels existent, ayez un technicien qualifié exécute l'installation.
n Observez des codes et des règlements locaux.
Page 132..........................................................................997-01520-02 Rev. F1
To Next Page
Loading...
