Web Interface
l The configurable range is 2 to 10 (2
2
to 2
10
).
l Default is 3
Return to IEEE 1588-2008 Annex J Recommended Default Settings check box
If you are not sure what selections to make, click on this button to get the standard settings.
Any slave should support theses settings as these settings meet the specification.
IEEE 1588-2008 Annex J Recommended Default Settings
Transport Protocol UDP
Sync Interval 1 pkt/1 sec
Delay Mechanism E2E
Packet TTL 1
E2E Delay Interval 1 pkt/1 sec
P2P Delay Interval 1 pkt/1 sec
Priority 1 128
Priority 2 128
Domain Number 0
Mean Announce Message Transmit Interval 2 sec
Announce Receipt Timeout Multiplier 3
PTP - Slaves
This page will show all the slaves associated with this SyncServer, both active and inactive
within the last 14 days. It shows when each slave was last accessed. The range of access
recording is from within 10 minutes to 14 days.
This page has a text box to log the slaves. The number of slaves tracked is shown below the
text box. For each slave, there are three parameters monitored:
n Address shows the IPaddress of the slave (xxx.xxx.xxx.xxx)
n Last Access shows the date and time of the last access, (MM-DD-YYYY HH:MM).
Page 58..........................................................................997-01520-02 Rev. F1
To Next Page
Loading...
