EasyManua.ls Logo

Microsemi SyncServer S350 - STATUS - Network

Microsemi SyncServer S350
210 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
STATUS - Network
n
Software Version: The software version.
n
Hardware Clock Version: The version of the software on the Hardware Clock.
n
Up Time: The time elapsed since the operating system started.
n
Load Average: A figure of merit for the operating system load” for the previous 1, 5, and
15 minutes (left to right).
n
Memory Used (Mbyte): The amount of memory occupied by the system.
n
Memory Free (Mbyte): The amount of free memory remaining.
n
Flash: The type of compact flash card installed.
n
CPU Vendor: The CPU vendor/manufacturer.
n
Model: The CPU model.
n
Number: The CPU number.
STATUS - Network
Network Status for each of the SyncServer's network ports:
n
The name of the Port.
n
The following Address information for each network port:
n
mac: The MAC Address.
n
v4: The IPv4 Address, if used.
n
v6 link: The IPv6 Address, if used.
n
The State of the physical network port device (not of the connection). An "Up Arrow"
means it is "running". A "Down Arrow" means it is "not running".
Management Port DNS Servers: Both user-entered and DHCP-assigned DNS Server
addresses that are available from the LAN1 port.
The SyncServer requires at least one valid DNS server to resolve domain names, which
may be used in NTP associations, and SMTP gateways (email). Without a DNS server, any
function that uses a DNS name instead of an IP address may be affected. These can include
NTP, password recovery, and email notification of alarms.
997-01520-02 Rev. F1.......................................................................... Page 25

Table of Contents

Related product manuals