Microsemi SyncServer S350 - Backing Up;Restoring Configurations

Halting the SyncServer
2.
Answer the Recovery Question and click the RESET button. The SyncServer sends a mes-
sage to the email address of the username.
3. When the email arrives, log into the SyncServer using the new password provided in the
email message.
4.
Change the password using the ADMIN - Users page.
If Recover Password wasn't enabled:
n If the SyncServer has multiple user accounts, you may be able to have another user log
in and change the password for you.
n If there is no other way to log into the SyncServer, use the hardware jumper to restore
the factory configuration. See Restoring the Factory Default Configuration (on page
167).
See also: Properties of User Names and Passwords (on page 23)
Halting the SyncServer
Microsemi recommends shutting the operating system down before removing the power.
Using the keypad/display interface:
1.
Press the MENU button.
2.
Select 3) Sys Control.
3.
Select 2) Shutdown.
4.
Press the ENTER button.
5. When the display shows "System Stopped - OK to Turn Power Off Now!" turn the power
off.
Or, using the web interface:
1.
Go to the SERVICES - Startup page.
2.
Select Halt and click the APPLY button.
3. Wait approximately 30 seconds before removing power.
CAUTION:StoppingtheSyncServer
Avoid removing power while the SyncServer is operating. Stop the operating system before
removing power.
ATTENTION : Évitez de couper le courant électrique pendant que le SyncServer fonctionne.
Veuillez fermer le système d'exploitation avant d'enlever le courant.
Backing Up/Restoring Configurations
SyncServer's configuration settings can be saved to a "backup" file, which is useful in the fol-
lowing scenarios:
997-01520-02 Rev. F1.......................................................................... Page 165