EasyManua.ls Logo

Microsemi SyncServer S350 - Restoringfrom Abackupfile; Transferringconfigurations; Restoringthe Factorydefault Configuration

Microsemi SyncServer S350
210 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Backing Up/Restoring Configurations
2.
Then use the SAVE AS or COPY button to download the backup file to a your workstation
or a USB device.
Restoringfrom aBackupFile
From the front panel keypad
1. Plug the USB flash drive into the 'target' SyncServer.
2. Wait 10 seconds.
3.
Press the MENU button, select 4) USB, and select 1) Restore Cfg.
4. The SyncServer reports "Restoring from USB Drive" and "Shutting down, please wait..."
5. When the SyncServer finishes rebooting, remove the USB flash drive.
From the web interface
On the WIZARDS - Restore web page, select one of the following options:
n Reset to Factory Defaults. See Restoring the Factory Default Configuration (on
page 167).
n Restore last backup from SyncServer.
n Restore backup from USB flash drive.
n Restore backup from a workstation hard-drive or network directory.
TransferringConfigurations
The user can transfer a configuration across multiple SyncServers to save time and effort,
provided they are running the same Software Version (displayed on the STATUS - General
page.
If you have physical access to the SyncServer, the easiest method for transferring the con-
figuration is to use a USB flash drive and the front panel keypad.
1. Create a backup file on a configured SyncServer, as described in Creating a Backup
File (on page 166).
2. Restore that backup file to another SyncServer as described in Restoring from a
Backup File (on page 167).
3.
IMPORTANT: When the SyncServer reboots, immediately change the IP address of LAN1
using the front panel MENU button as described in Configuring LAN1 (on page 148).
This step resets all of the network port addresses and prevents network address col-
lisions with the previous SyncServer.
4.
Log in and use the NETWORK - Ethernet page to configure the network ports.
5.
On the SYSTEM - General page, update the Hostname.
RestoringtheFactoryDefaultConfiguration
Note: The SyncServer S350i does not include a GPS receiver.
The user may wish to restore the factory default configuration in a variety of circumstances:
997-01520-02 Rev. F1.......................................................................... Page 167

Table of Contents

Related product manuals