Microsemi SyncServer S350 - Page 186

Tasks
GPS GPS UHF satellite positioning
==============================================
The following ref ids are used by the SyncServer:
==============================================
GPS GPS satellite)
IRIGIRIG B timecode
PPS Ext. 1PPS input
E10MExt. 10MHz input
FREE Internal Clock
FLYInternal Clock after the Hardware
Clock reference is lost
=============================================="
::= {ntpSystem 6}
ntpSysRefTime OBJECT-TYPE
SYNTAX DisplayString (SIZE(1..40))
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"NTP Reference Timestamp.This is the time,
in timestamp format (converted to DisplayString),
when the local clock was last updated.If the
local clock has never been synchronized, the value
is zero."
::= {ntpSystem 7}
ntpSysPollOBJECT-TYPE
SYNTAXInteger32
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"Minimum interval between transmitted messages, in
seconds as a power of two. For instance, a value
of six indicates a minimum interval of 64 seconds."
::= {ntpSystem 8}
ntpSysPeerOBJECT-TYPE
SYNTAX Unsigned32
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"Current synchronization source.In stratum > 1 this
variable returns the decimal representation of the
IPv4 address of its current peer. In stratum = 1 this
variable returns the decimal representation of the
hardware clock which is 2981759."
::= {ntpSystem 9}
ntpSysPhase OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..40))
Page 186..........................................................................997-01520-02 Rev. F1