31
(2) Please use [↑] or [↓] to select the item needed.
(3) If needed, please press S1 or ←→ [PROG] to switch.
(4) Press [Exit] to exit when completed.
(1) Tester ID
Allows assigning an ID for this tester.
(2) Test Alarm
This function provides alarms for test results; there are a total of 4 options that can be set according
to the needs.
ALL There is sound whether the result of the test DUT is good or failed.
OFF There is no sound whether the result of the test DUT is good or failed.
Good sound There is only sound when the result of the test DUT is good.
Poor sound There is only sound when the result of the test DUT failed.
(3) Consecutive Alarm
When errors occur during testing, a continuous alarm will sound.
On: Enables the consecutive alarm function.
Off: Disables the consecutive alarm function.
(4) Display Test Data
This function is used to set the display of the test statistical data and print format; there are a total of
three options.
ALL Display and print test data whether there are errors or not.
None Do not display and print test data whether there are errors or not.
Error step Display and print error step.
(5) Auto Print Data
Whether to print test data automatically. There is a total of two options and the default value is
│Key│.
Key: Auto print data mode is off and keys are used to control whether to print the test data.
Auto: Auto print data mode is on.
(6) Output Signal
Selects signal output mode. There are three modes. Continuous signal, pulse signal, and off.
Off: Remote control with no output.
Continuous signal: Remote control is continuous output until the next test.
Pulse signal: Remote control is pulse output of 100ms.
(7) Step Trigger
Selects the step trigger mode. There are three modes. Key, auto, external.
(8) Test File
Choose whether to use a single file for testing or step file testing.
To Next Page
Loading...
Need help?
General
