62
4.2 Comprehensive Test Implementation
After the settings above are completed, comprehensive test implementation can be performed. Since
the operating procedures are different, it can be divided into two types: Real time test and Existed test;
individual descriptions are as follows:
4.2.1 Real Time Test
This part sets the test conditions saved in the main memory as the test condition and performs test to
test DUTs in real time. It is the most commonly used test method. Its step descriptions are as follows:
(1) First check whether the test condition settings are correct.
(2) Press [Mode] to display the test mode setting screen.
(3) Check and confirm whether the test mode settings are correct, and change according to your
needs.
(4) After confirming there are no errors, press [EXIT] to exit and return to the main screen.
(5) Press [TEST] to start testing.
(6) When the test is complete or if the test needs to be interrupted, please press [EXIT] to exit.
4.2.2 Existed Test
You can load files saved in the memory to the main memory to perform testing; instructions are as
follows:
(1) Press [File].
(2) Please use [↑] or [↓] to move the cursor to select the file name to load.
(3) After confirming, press [Enter]; the tester will start loading the selected file into the main memory.
(4) At this time the LCD screen will return to the main screen and the name of the file you selected
will be displayed for current file; file loading has been completed at this time.
(5) Please press [EXIT] to exit and return to the main screen.
To Next Page
Loading...
Need help?
General
