52
(2) The LCD screen will display as follows:
(3) Please use [↑] or [↓] to select the item you want to set.
(1) Maximum conductance value (Max. Conductance): Please use the number buttons to enter a
value according to your needs as the upper limit of the cable conductance.
(2) Minimum conductance value ((Min. Conductance): Please use the number buttons to enter a
value according to your needs as the lower limit of the cable conductance.
(3) Conductance offset(Cond. Offset): Resistance value can be entered to increase or decrease the
resistance of the fixture.
(4) Conductance mode: Use S1 [PROG] to switch between serials, radiation, or composite.
(5) Intermittence limit: Resistance value can be entered to be used as the basis to determine the test
result.
(6) Intermittence time: A time value can be entered to be used as the continuation time for the test.
(7) Conductance Net (Cond. Net): Allows importing of the O/S learned into component edit.
To Next Page
Loading...
