Mid-tech ARC 6000 - Page 41

5-3
98-05012
R3
ARC-6000
Check cables, from “ Flow
Control” port on back of
console, to valve for bad
connections, abrasions, and
pinched or broken wires.
Check for blown fuses
Check cables, from “ Boom
Interface” port on back of
console, to valves for bad
connections, abrasions, and
pinched or broken wires.
Check for blockage of the
flow meter rotor.
Check cables, from “ Flow
Control” port on back of
console, to flowmeter for bad
connections, abrasions, and
pinched or broken wires.
Contact your MID-TECH
dealer if you see this message
on an ARC controller.
Check “ Flow Control”
connections on the back of
the console. Secure if loose.
Check in-line fuse (optional)
near positive battery connec-
tion.
Check valve control signals.
Check cables, from “ Flow
Control” port on back of
console, to valve, for bad
connections, abrasions, and
pinched or broken wires.
Consult Chapter 2 for the
correct switch sequence.
Err 3
Pump L
(Cont.)
Err 4
Err 5
Pump L
Err
Boom valves are not opening.
Flow in the product line.
Not a diagnostic function in
the ARC.
Application rate is exceeding
the target rate by 15%. Valve
is not responding.
Incorrect switch sequence is
selected on the console.