Midea M-thermal Mono Series - 3 ACCESSORIES; Included Accessories; 4 BEFORE INSTALLATION

The thermistor can be used to detect temperature of
water.If domestic hot water tank is installed only, the
thermistor can work as T5. If boiler is installed only, the
thermistor can worke as T1B. If both unit are installed, an
addtional thermistor is needed(please contact the
supplier).The thermistor should connect to the
corresponding port in the main control board of
hydraulic(refer to 9.3.1Main control board of hydraulic
module).
3 ACCESSORIES
3.1 Accessories supplied with the unit
06
Before installation
Be sure to confirm the model name and the serial number of the unit.
Handling
Due to relatively large dimensions and heavy weight, the unit should only be handled using lifting tools with slings. The slings
can be fitted into foreseen sleeves at the base frame that are made specifically for this purpose.
4 BEFORE INSTALLATION
In heating mode, the water flowing temperature
(TW_out) range in different outdoor temperature (T4) is
listed below:
In DHW mode, the water flowing temperature(TW_out)
range in different outdoor temperature(T4) is listed below:
In cooling mode, the water temperature flowing
(TW_out) range in different outdoor temperature(T4) is
listed below:
Operation range by heat pump with possible limitation and protection.
If IBH/AHS setting is valid, only IBH/AHS turns on;
If IBH/AHS setting is invalid, only heat pump turns on.
Operation range by heat pump with possible
limitation and protection.
Maximum inlet water temperature line for heat pump
operation.
Operation range by heat pump with possible
limitation and protection.
Maximum inlet water temperature line for heat pump
operation.
If IBH/AHS setting is valid, only IBH/AHS turns on;
If IBH/AHS setting is invalid, only heat pump turns on.
Installation and owner’s
manual(this book)
Quantity
Operation manual
Technical data manual
Y-shape filter
Shape
Name
1
1
1
1
Installation Fittings
Wired controller
Thermistor for domestic
hot water tank or zone2
water flow or balance tank
1
1
Drian hose
1
Energy label 1
Tighten belt for
customer wiring use
2
3