English - 28
003-2915-99
© Midmark Corporation 2018
Cycle Operation - continued...
Caution
• The processed load and inner surfaces will be hot. Avoid contact with hot surfaces. Failure
to do so could result in serious burns.
• Do not apply downward pressure to the open sterilizer door while unloading the chamber.
Doing so could cause the sterilizer to tip resulting in serious burns or injury from the trays or
instruments sliding out of the chamber.
Step 4: Remove processed load from the chamber.
A) Refer to “Using the Optional Tray/Cassette Tool” later in this manual.
B) Sterilizer is now ready for another cycle.
Post-Sterilization Processing
apply.
This protocol should be followed by all personnel responsible for handling sterilized items.
Stage of Cycle Description Display
Manual Door Open
Pertains only to
M9D Steam Sterilizer
pressure inside chambers reaches zero
to indicate Operator to open door. The
(drying mode) position. The audible signal
will continue to repeat every minute until
Caution
The processed loads may still be wet if the Dry Cycle is aborted
prior to completion. Always allow processed loads to dry in the
sterilizer before they are handled to avoid re-contamination.
Drying
pressing the STOP button.
When Drying time reaches 0:00...
Cycle Complete
seconds.
To Next Page
Loading...