English - 8
003-2915-99
© Midmark Corporation 2018
Controls and Indicators
The accompanying tables describe the function of each control / indicator.
Control Function
Display See illustration
remaining cycle time is displayed as well as temperature and
pressure. Display also shows error message if a malfunction
Troubleshooting section of this manual for a
Informational / Error Messages.
Unwrapped button
270°F (132°C) for 3:00 minutes / 30 minute drying cycle.
Pouches button
paper / plastic sterilization pouches or wrapped instruments
at: 270°F (132°C) for 4 minutes / 30 minute drying cycle.
Packs button
250°F (121°C) for 30 minutes / 30 minute drying
cycle.
Handpieces
button
270°F (132°C) for 4 minutes / 30 minute drying cycle.
Start button
pressing Start will activate heater for 10 minutes.
Stop button
Terminates selected program or function.
1 or 2 buttons
run in these cycles
must be validated
for sterilization by
the user.
Programmable cycle buttons that allow an operator to create two
different programmed cycles for special applications. Sterilization
-
dure can be adjusted or changed.
Caution
These cycles are not FDA cleared and validation of sterility
of items processed using them is the responsibility of the
user.
To Next Page
Loading...