Settings option
100
Dispensing correction factor (D1 to D 13)
The correction factor can be used if an adjustment is made to the li-
quid dispensing. If, e.g. the dispensing agent for Dispensing pump D
1 were altered (to a higher concentration), a rapid modification can be
made with the correction factor.
Calculate the correction factor using the following formula:
Correction factor D1 =
New quantity Dos-p. D1
Current quantity Dos-p. D1
Access the following content:
You have the following options:
– 0.01 to 1.99
– 2
Once you exit the supervisor level, the new dispensing amounts are
used in the programmes but the programming is not changed.
To Next Page
Loading...
