Miele PW 413 - Information on Mops; Information on Finish Mops Programme

Programme chart - MOPSTAR
41
Mops chemo-thermal dis-
infection + finish*****
60°C Fill ratio/Load
size
Material Cotton, viscose, polyester and microfibre mops
1:10
PW 413 - 13kg
PW 418- 18kg
For number,
see
"Mops per load"
chart
Programme se-
quence
Programme sequence as for Mops thermal disin-
fection, then:
Finishing agent, damp
or activate block:
Damp, wet, dripping wet
Finish mops
Material Cotton, viscose, polyester and microfibre mops
Programme se-
quence
1 rinse
Finishing agent, damp
or activate block:
Damp, wet, dripping wet
* The Cooldown block can be activated if required, e.g. for gently cooling down microfibre mops.
** Programme locked. If a programme is locked, after 1minute it can no longer be stopped and cancelled with the finish
button.
*** The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time, and dosages)
must be set on site to suit cleaning agents and disinfectants.
Information on Mops...+ finish programme
With the Mops . . . + finish programme the mops are ready to use and already impreg-
nated with cleaning agent and disinfectant. To achieve this, following washing or disinfec-
tion there is a finishing stage and then a final spin.
Dosage amounts must be set on site and the standard of disinfection must be checked.
Information on Finish mops programme
The Finish mops programme is suitable for the subsequent finishing of clean and dry
mops. A disinfecting agent is applied during finishing.
Dosage amounts must be set on site and the standard of disinfection must be checked.