Miele PW 413 - Programme Chart - MOPSTAR; Contract Cleaning Programmes; Mop Programmes

Programme chart - MOPSTAR
39
Contract cleaning programmes
These programmes are suitable for washing, disinfection and conditioning (at different hu-
midity levels) of mops of cotton, blended or microfibre fabric, entrance mats, polishing
pads and cleaning cloths used in facility management.
To avoid recontamination, the water for the rinse cycles in the disinfection programmes is
not supplied via the detergent dispensing compartment.
Mop programmes
Avoid coarse soiling in the machine.
 Shake out the mops before putting them in the machine.
Mops standard* 60°C / 90°C Fill ratio/Load
size
Material Cotton, viscose, polyester and microfibre mops
1:10
PW 413 - 13kg
PW 418- 18kg
For number,
see
"Mops per load"
chart
Programme se-
quence
Pre-spin
Pre-rinse
+ 2nd pre-rinse, optional
Main wash 60°C (selectable: cold to 90°C), Cool
down can be activated
2 rinses
Final spin
Mops thermal disinfec-
tion***
90°C
Material Cotton, viscose, polyester and microfibre mops
Programme se-
quence
Pre-spin
Pre-rinse
+ 2nd pre-rinse, optional
Disinfection 90°C, 10min., Cool down can be
activated
3 rinses
Final spin
* The Cooldown block can be activated if required, e.g. for gently cooling down microfibre mops.
** Programme locked. If a programme is locked, after 1minute it can no longer be stopped and cancelled with the finish
button.
*** The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time, and dosages)
must be set on site to suit cleaning agents and disinfectants.