EasyManuals Logo

Miller Auto-Continuum 350 User Manual

Miller Auto-Continuum 350
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
OM-273473 Page 15
SECTION 5 INSTALLATION
! Special installation may be required
where gasoline or volatile liquids are
presentsee NEC Article 511 or CEC
Section 20.
! Do not stack units. Beware of tipping.
1 Lifting Eye
2 Lifting Forks
Use lifting eye or lifting forks to move unit.
If using lifting forks, extend forks beyond
opposite side of unit.
3 Hand Cart
Use cart or similar device to move unit.
4 Line Disconnect Device
Locate unit near correct input power supply.
5-1. Selecting A Location
4
18 in.
(460 mm)
18 in.
(460 mm)
OR
1
2
Movement
Location And Airflow
Loc_continuum 2015-07
3
OR
! Do not move or operate
unit where it could tip.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miller Auto-Continuum 350 and is the answer not in the manual?

Miller Auto-Continuum 350 Specifications

General IconGeneral
BrandMiller
ModelAuto-Continuum 350
CategoryWelding System
LanguageEnglish

Related product manuals