Miller Bobcat 260 User Manual

OM-286504 Page 24
F
Complete Parts List is available at www.MillerWelds.com
5-4. Engine Prestart Checks
0
1/2
1
H
0000
Check all fluids daily. Engine must be cold
and on a level surface. Unit is shipped with
10W-30 synthetic blend engine oil.
F
Follow run-in procedure in engine
manual.
F
This unit has a low oil pressure shut-
down switch. However, some conditions
may cause engine damage before the
engine shuts down. Check oil level
often and do not use the oil pressure
shutdown system to monitor oil level.

Complete Parts List available at www.MillerWelds.com
OM-249336 Page 6
250916-A
0
1/2
1
H
0000
1
2
3
3
4
5
Fuel
1 Expansion Space
2 Gasoline
3 Full
Open left side access door.
NOTICE – Engine flooding may occur if fuel
level is above Max Fill Level on tank.
Add fresh fuel before starting engine the first
time (see maintenance label for specifica-
tions). Stop fueling when fuel level reaches
Max Fill Level on tank. Do not top off tank. Al-
ways leave room for expansion. Check fuel
level on a cold engine before use each day.
To check fuel level, turn Engine Control
switch to Run/Idle position. Fuel/hourmeter
indicates fuel level in tank.
Close left side access door. Open top service
door.
 Complete Parts List available at www.MillerWelds.com
OM-249336 Page 6
250916-A
0
1/2
1
H
0000
1
2
3
3
4
5
Oil
4 Oil Fill
5 Oil Check
F
Do not exceed the "Full" mark on the oil
level dipstick. The fuel pump may oper-
ate erratically if crankcase is overfilled.
After fueling, check oil with unit on level sur-
face. If oil is not up to full mark on dipstick,
add oil (see maintenance label).
Use fuel/hourmeter to determine hours until
next recommended oil change (see Front
Panel Controls).
F
To improve cold weather starting:
Keep battery in good condition.
Store battery in warm area.
Use correct grade oil for cold weather.
Close top service door.

Miller Bobcat 260 Specifications

General

Brand	Miller
Model	Bobcat 260
Category	Welding System
Language	English