OM-286504 Page 43
F
Complete Parts List is available at www.MillerWelds.com
8-6. Changing Engine Oil, Oil Filter, And Fuel Filter
Stop engine and let cool.
1 Oil Drain Valve
Change engine oil and filter according to en-
gine owner’s manual.
NOTICE – Close valve and valve cap before
adding oil and running engine.
Fill crankcase with new oil to full mark on dip-
stick (see Section 8-2).
2 Fuel Filter
3 Fuel Line
Replace line if cracked or worn. Install new
filter with arrow pointing in the direction of
fuel flow. Wipe up any spilled fuel.
Start engine, and check for fuel leaks.
Stop engine, tighten connections
as necessary, and wipe up fuel.
Reset oil maintenance countdown by leaving
the engine off and flipping Engine Control
switch from Run/Idle to Run three times.
OM-222 Page 1
allen_wrench
NGO’s
tools/
flathead philips head wrench
pliers
knife
heavy-duty workclamp light-duty workclamp wirecutter frontcutter
allen_set
needlenose
steelbrush nutdriver
chippinghammer
solderiron
stripcrimp
drill
torque wrench
socket wrench
hammer awl file
crimper
paintbrush
feelergauge flashlight ruler
toothbrush
greasegun
qtip (swab)
vicegrip
handream
punch
filterwrench
strapwrench
airgun
solvent pinextractor eprompuller pipewrench
torque screwdriver
crescent wrench
OM-222 Page 1
NGO’s
tools/
helmet weldshield faceshield
glasses hairdryer cclamp rpmmeter benchvise
popriveter
oilcan filtersocket hacksaw belttensiongauge sealant_1
snapringpliers linepliers pencil fusepuller mallet scissors
tape
rubbergloves weldgloves earmuffs electrodewrench
pinextractor2
tip_dress
sealant_2 pump pliers
T_allen
pinextractor (141761)
SOAP
bar soap
Liquid soap
Paper Clip
Needle-Nose Vise Grip
Ground Strap
Thermal Compound
Trowel
Chisel
Torx
ear plugs
To Next Page
Loading...
Need help?
General
