EasyManuals Logo

Miller Bobcat 260 User Manual

Miller Bobcat 260
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
OM-286504 Page 41
F
Complete Parts List is available at www.MillerWelds.com
8-3. Servicing Air Cleaner
oil
1
2
oil
1
2
Stop engine.
NOTICE Do not run engine without air
cleaner or with dirty element. Engine dam-
age caused by using a damaged element is
not covered by the warranty.
1 Precleaner
Wash precleaner with soap and water solu-
tion. Allow precleaner to air dry completely.
Spread 1 tablespoon SAE 30 oil evenly into
precleaner. Squeeze out excess oil.
2 Element
Replace element if damaged, dirty, or oily.
8-4. Electronic Fuel Injection (EFI) System And Servicing Information
NOTICE EFI system components can be damaged if these precautions are not followed:
l Do not disconnect or reconnect the wiring harness connector to the control unit or any individual components with the Engine Control switch
On.
l Never attempt to service any fuel system component while engine is running or the Engine Control switch is On.
l Clean any joint or fitting with approved cleaning solvent before opening to prevent dirt from entering the system.
l Cleanliness is essential and must be maintained at all times when servicing or working on the EFI system. Dirt can cause significant
problems.
l Always depressurize the fuel system through the test valve in the fuel rail before disconnecting or servicing any fuel system components.
l Do not used compressed air if the system is open.
l Avoid direct water or spray contact with system components.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miller Bobcat 260 and is the answer not in the manual?

Miller Bobcat 260 Specifications

General IconGeneral
BrandMiller
ModelBobcat 260
CategoryWelding System
LanguageEnglish

Related product manuals