OM-291417 Page 25
F
Complete Parts List is available at www.MillerWelds.com
5-5. Engine Prestart Checks
Check all fluids daily. Engine must be cold
and on a level surface. Unit is shipped with
synthetic blend 10W-30 engine oil.
F
Follow run-in procedure in engine
manual.
F
This unit has a low oil pressure shut-
down switch. However, some conditions
may cause engine damage before the
engine shuts down. Check oil level
often and do not use the oil pressure
shutdown system to monitor oil level.
Fuel
1 Fuel Fill Cap
Add fresh fuel before starting engine the first
time (see maintenance label for specifica-
tions). Stop fueling when fuel reaches bottom
of fuel fill bowl. Do not over fill. Fuel tank has
built in air expansion volume. Do not top off
tank. Check fuel level on a cold engine before
use each day.
To check fuel level, turn Engine Control
switch to Run/Idle position. Fuel/hourmeter
indicates fuel level in tank.
Oil
Open top service door.
2 Oil Fill
3 Oil Check
F
Do not exceed the "Full" mark on the oil
level dipstick. The fuel pump may oper-
ate erratically if crankcase is overfilled.
After fueling, check oil with unit on level sur-
face. If oil is not up to full mark on dipstick,
add oil (see maintenance label).
Use fuel/hourmeter to determine hours until
next recommended oil change (see Front
Panel Controls).
F
To improve cold weather starting:
Keep battery in good condition.
Store battery in warm area.
Use correct grade oil for cold weather.
Close top service door.
To Next Page
Loading...
Need help?
General
