OM-291417 Page 38
F
Complete Parts List is available at www.MillerWelds.com
SECTION 8 – MAINTENANCE AND TROUBLESHOOTING
8-1. Routine Maintenance
Stop engine before maintaining.
F
See Engine Manual and Maintenance Label for important start-up, service, and storage information. Service Engine more often if used
in severe conditions.
F
Recycle engine fluids.
Maintenance Schedule
Every
8
Hours
Every
20
Hours
Every
25
Hours
Every
50
Hours
Every
100
Hours
Every
200
Hours
Every
500
Hours
Reference
Fuel and
Oil
Check fuel and oil
levels.
Clean any fuel and/or
oil spills.
l Section 5-5
Spark Ar-
restor
Screen
Check and Clean
l Section 8-7
Air
Cleaner
Wrapper
Clean
l Section 8-3
Weld Ter-
minals
Clean
l
Battery
Terminals
Clean
l
Cooling
System
Clean
l
Engine
Manual
Oil Change l Section 8-5
Air
Cleaner
Element
Check and replace if
necessary l Section 8-3
Labels Replace any unread-
able labels
l
Spark
Plug Gap
Check
l
Engine
Manual
Oil Filter Replace l Section 8-5
Fuel Filter Replace l Section 8-5
Weld
Cables
Check cables for any
signs of damage and
replace if necessary.
l
Brushes* Check brushes and re-
place if necessary
l
Slip
Rings*
Check slip rings for
any signs of wear or
damage
l
Spark
Plug
Replace
l
Engine
Manual
*To be done by factory authorized service agent.
NOTICE – This equipment meets US EPA Evaporative Standards. Be sure fuel system replacement parts meet EPA Evaporative standards.