EasyManuals Logo

Miller Bobcat 3 Phase User Manual

Miller Bobcat 3 Phase
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
A complete Parts List is available at www.MillerWelds.com
OM-4436 Page 15
5-2. Engine Prestart Checks
804 802-A / 227 912-A
Check all fluids daily. Engine must
be cold and on a level surface. Unit
is shipped with 10W30 engine oil.
Follow run-in procedure in en-
gine manual.
This unit has a low oil pressure
shutdown switch. However,
some conditions may cause
engine damage before the en-
gine shuts down. Check oil lev-
el often and do not use the oil
pressure shutdown system to
monitor oil level.
Fuel
To help prime the fuel system at ini-
tial start-up, fill tank with fresh fuel
(see maintenance label for specifi-
cations). Always leave filler neck
empty to allow room for expansion.
Check fuel level on a cold engine
before use each day.
Oil
Do not exceed the ”Full” mark
on the oil level dipstick. The
fuel pump may operate errati-
cally if crankcase is overfilled.
After fueling, check oil with unit on
level surface. If oil is not up to full
mark on dipstick, add oil (see main-
tenance label).
To improve cold weather
starting:
Keep battery in good condition.
Store battery in warm area.
Use correct grade oil for cold
weather.
Full
Full
Gasoline
0
1/2
1
H
0000

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miller Bobcat 3 Phase and is the answer not in the manual?

Miller Bobcat 3 Phase Specifications

General IconGeneral
BrandMiller
ModelBobcat 3 Phase
CategoryWelding System
LanguageEnglish

Related product manuals