OM-286308 Page 14
F
Complete Parts List is available at www.MillerWelds.com
SECTION 5 – SPECIFICATIONS
5-1. FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy, and if not installed and used in accordance with instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
l Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications that are not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
5-2. RSS (ISED) Compliance/Conformité au CNR (ISDE)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy, and if not installed and used in accordance with instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
These devices contain licence−exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s
licence−exempt RSS(s). Operation is subject to the following two conditions:
l This device may not cause interference.
l This device must accept any interference, including interference that may cause undesired operation of the device.
Ces dispositifs contiennent un/des émetteur(s)−récepteur(s) exempt(s) de licence(s) qui se conforme(nt) avec un/des CNR exempt(s) de li-
cence(s) émises par Innovation, Sciences et Développement économique Canada. Leur fonctionnement est soumis aux deux conditions
suivantes:
l Ces dispositifs ne doivent causer aucune interférence nuisible.
l Ces dispositifs doivent accepter toutes les interférences, y compris celles qui pourraient provoquer un fonctionnement non désirédu
dispositif.
5-3. Software Licensing Agreement
The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at
https://www.millerwelds.com/eula and are incorporated by reference herein.
5-4. Information About Default Weld Parameters And Settings
NOTICE – Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical
welding parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are
for reference purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriate-
ness of all parameters and settings should be evaluated and modified by the end user as necessary based upon application-specific require-
ments. The end user is solely responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld
parameters and settings, and ultimate quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warran-
ties including any implied warranty of fitness for a particular purpose.
To Next Page
Loading...
