OM-286308 Page 27
SECTION 8 – TROUBLESHOOTING
8-1. Troubleshooting Table
Trouble Remedy
Remote completely inoperative. Red
wireless status light not lit on
transceiver.
Make sure power source is on.
Make sure receiver is connected properly to welding power source. (see Section 6-3).
Red wireless status light is on, but no
or limited control with remote, or con-
trols will not program.
Check and if necessary, replace batteries in remote hand or foot control.
Make sure components are properly paired. (see Section 7-5 and/or 7-6).
Make sure the controls are within working area, and without interferences.
Device will not pair. Move hand control or foot control within 1ft (25.4cm) of the receiver during pairing.
To Next Page
Loading...
