Miller CST 280 - Routine Maintenance

OM-258 035 Page 29
SECTION 7 − MAINTENANCE AND TROUBLESHOOTING
7-1. Routine Maintenance
! Disconnect power before
maintaining.
 Maintain more often during severe
conditions.
 = Check  = Change  = Clean  = Replace
* To be done by Factory Authorized Service Agent
Reference
Every
3
Months
 Unreadable Labels  Weld Terminals  Damaged Gas Hose
 Damaged Weld Cables  Damaged Cords  Damaged Torch Cable
Every
6
Months
OR
! Do not remove case
when blowing out in-
side of unit
(see Section 7-2) .
 Inside Unit
7-2. Blowing Out Inside Of Unit
! Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
258 649-A