Miller FieldPro Remote CE - Table of Contents

TABLE OF CONTENTS
SECTION 1 − SAFETY PRECAUTIONS - READ BEFORE USING 1.................................
1-1. Symbol Usage 1.......................................................................
1-2. Arc Welding Hazards 1.................................................................
1-3. Additional Symbols For Installation, Operation, And Maintenance 3.............................
1-4. California Proposition 65 Warnings 4......................................................
1-5. Principal Safety Standards 4.............................................................
1-6. EMF Information 4.....................................................................
SECTION 2 − CONSIGNES DE SÉCURITÉ − LIRE AVANT UTILISATION 5...........................
2-1. Symboles utilisés 5.....................................................................
2-2. Dangers relatifs au soudage à l’arc 5......................................................
2-3. Dangers supplémentaires en relation avec l’installation, le fonctionnement et la maintenance 7.....
2-4. Proposition californienne 65 Avertissements 9..............................................
2-5. Principales normes de sécurité 9.........................................................
2-6. Informations relatives aux CEM 9.........................................................
SECTION 3 − DEFINITIONS 10..................................................................
3-1. Additional Safety Symbols And Definitions 10................................................
3-2. Miscellaneous Symbols And Definitions 10..................................................
SECTION 4 − SPECIFICATIONS 11..............................................................
4-1. Serial Number And Rating Label Location 11................................................
4-2. Unit Specifications 11....................................................................
4-3. Duty Cycle And Overheating 11...........................................................
4-4. Dimensions And Weight 12...............................................................
4-5. Environmental Specifications 13...........................................................
SECTION 5 − INSTALLATION 14................................................................
5-1. Selecting a Location 14..................................................................
5-2. Proper Method To Carry Remote 15........................................................
5-3. Remote 14 Receptacle Information 15......................................................
5-4. Electrical Service Guide 16...............................................................
5-5. Connecting 3-Phase Input Power 17.......................................................
5-6. Weld Output Receptacles And Selecting Cable Sizes* 19......................................
5-7. Stick Connections 20....................................................................
5-8. TIG Lift-Arct Connections 21.............................................................
5-9. Connecting Work Sense Lead To Remote 22................................................
5-10. Optional Method Of Combining Wok Sense Lead With Work Clamp 22...........................
5-11. Connecting Basic Feeder 23..............................................................
5-12. Setting Inductance 23....................................................................
5-13. Installing Welding Power Source Onto Rack 24..............................................
5-14. Connecting To Remote 25................................................................
5-15. Volt Sense Lead And Work Cable Connections For Multiple Welding Arcs 26......................
SECTION 6 − OPERATION 28...................................................................
6-1. Welding Power Source And Remote Interface Controls 28.....................................
6-2. Welding Power Source And Remote Interface Operation Description 29..........................
6-3. Lift-Arc TIG Procedure 30................................................................
6-4. Stick Start Procedure − Scratch Start Technique 30...........................................
6-5. Carbon Arc Gouging 31..................................................................
6-6. Restoring Factory Defaults 31.............................................................
6-7. Viewing Software Revision 31.............................................................