Miller Syncrowave 350 LX - Start Time;Spot Time Control and Start Current Control

OM-356 Page 31
5-15. Start Time/Spot Time Control And Start Current Control
1 Sequence Selection Switch
Place switch in Start position.
2 Start Time/Spot Time Control
Use control to select 0−15 seconds
of start time.
3 Start Current Control
Use start control to select a starting
current (3−400 amps) that is differ-
ent from the weld current. Note:
Start current can be used with or
without a remote control.
Application:
Start current can be used while
GTAW welding to assist in preheat-
ing cold material prior to depositing
filler material, or to ensure a soft
start. Start current can also be used
for SMAW to ensure a more consis-
tent arc strike.
2
3
1
1
2
3
(CE Nameplate Only)