Miller Syncrowave 350 LX - SECTION 6 - MAINTENANCE & TROUBLESHOOTING; Routine Maintenance

OM-356 Page 36
SECTION 6 − MAINTENANCE & TROUBLESHOOTING
6-1. Routine Maintenance
Y Disconnect power before maintaining.
3 Months
Replace
Unreadable
Labels
Clean And
Tighten
Weld
Terminals
Repair Or
Replace
Cracked
Weld
Cables
Adjust Spark
Gaps
Replace
Cracked
Parts
14-Pin Cord
Gas Hose
Torch Cable
6 Months
Blow Out Or Vacuum Inside,
During Heavy Service, Clean Monthly
OR
Y Warranty is void if machine fails
due to contaminates inside.
6-2. Circuit Breaker CB1
Ref. ST-801 972-C
Y Turn off power before reset-
ting breaker.
1 Circuit Breaker CB1
If CB1 opens, high frequency and
output to the 115 volts ac duplex re-
ceptacle stop. Press button to reset
breaker.
1