EasyManuals Logo

Millipore Synergy R User Manual

Millipore Synergy R
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Installation
16
Purging Air from the System
A
At this time you should have installed the SynergyPak cartridge,
Barbed Fitting and the Tygon Tubing. Air trapped in the SynergyPak
cartridge should now be purged from the system.
Press the Dispensing Button once to put the system into
DISPENSING mode (A).
Dispense about 3-4 Litres of water from the system.
Hydrating the System
At this time, the Final Filter is not installed. Leave the system
overnight or for several hours in PRE OPERATE mode (
see
Section
Operating Modes
). The system will regularly recirculate water and
rinse off purification media inside the SynergyPak cartridge. Do not
leave the system in STANDBY mode.
(The next morning) Press the Dispensing Button once to put the
system into DISPENSING mode.
Allow about 1 Litre of water to be dispensed from the system.
Press the Dispensing Button once again. The system will finish
dispensing water.
Remove the Tygon Tubing and the Barbed Fitting from the POU
Dispenser.
The Final Filter needs to be installed.
(See Section Installation and Rinsing of the Final Filter).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Millipore Synergy R and is the answer not in the manual?

Millipore Synergy R Specifications

General IconGeneral
BrandMillipore
ModelSynergy R
CategoryWater Filtration Systems
LanguageEnglish

Related product manuals