What to do if the UV lamp alarm is displayed on my Millipore Water Filtration System?
If the red UV Lamp Alarm is still displayed on your Millipore Water Filtration System, power OFF the system and reinstall the UV Lamp. If the alarm persists, contact Millipore for assistance.
How to fix the UV system on my Millipore Water Filtration System?
If you are experiencing issues with the UV system on your Millipore Water Filtration System, it might be due to an exhausted UV timer, replace the UV Lamp. After installing a new UV lamp, reset the UV Timer.
Why is the display screen blank on my Millipore Water Filtration System?
A blank display screen on your Millipore Water Filtration System can occur if the power cord isn't properly plugged in, so ensure it's connected. Another reason might be the absence of electrical power from the source. If the main power fuse is blown, it is recommended to contact Millipore for assistance.
What to do if there is low or no water flow from my Millipore Water Filtration System?
If you're experiencing low or no water flow when pressing the dispensing button on your Millipore Water Filtration System, it could be due to an air-locked Millipak filter. Try venting all air from the Millipak filter. Alternatively, the final filter may be clogged, requiring a replacement.
How to fix inaccurate auto-dispensing mode on Millipore Water Filtration Systems?
Inaccurate auto-dispensing mode on your Millipore Water Filtration System may be due to an uncalibrated product water flow rate; in this case, you should calibrate the product water flow rate. A clogged or airlocked final filter can also cause this issue, so try replacing the final filter.
What to do if the SynergyPak is not installed correctly in my Millipore Water Filtration System?
If the SynergyPak is not installed correctly in your Millipore Water Filtration System, reinstall it. If the red Pack Alarm is still displayed after reinstallation, contact Millipore for further assistance.
Why isn't the last resistivity value displayed on my Millipore Water Filtration System?
If the last product resistivity value isn't displayed when pressing the '-' button in PRE OPERATE mode on your Millipore Water Filtration System, it could be because a measurement wasn't taken during dispensing or recirculation. Manually dispense or recirculate water to initiate a product resistivity reading. It may also be that the value is out of measurement range.
Essential safety precautions and warnings for operating the Synergy system.
Steps to prepare the Synergy system for installation, including removing shipping components.
Guide for connecting the main feedwater tubing to the Synergy system.
Detailed steps for installing the SynergyPak cartridge into the system.
Step-by-step process to calibrate the product water flowrate for accuracy.
Procedure to configure the resistivity setpoint for monitoring and alerts.
Instructions on how to obtain purified water using the dispensing button.
Step-by-step guide for removing and installing a new SynergyPak cartridge.
Instructions for replacing the final filter in the water purification system.
Guide for replacing the UV lamp in the Synergy UV system.
How to check the UV lamp's remaining life and reset the timer after replacement.
General| Display | Touchscreen |
|---|---|
| Type | Water purification system |
| Water Quality | Ultrapure, Type 1 |
| Filtration Technology | Reverse osmosis, ultrafiltration |
| Resistivity | 18.2 MΩ·cm |
| TOC | <5 ppb |
| Pyrogens (Endotoxins) | <0.001 EU/mL |
| RNases | Not detected |
| DNases | Not detected |
| Flow Rate | Up to 2.0 L/min |
| Connectivity | RS-232, Ethernet |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Power Requirements | 100-240 V, 50/60 Hz |
To Next Page