USING THE SYNERGY
5-4 HOW TO VIEW THE PRODUCT RESISTIVITY AND TEMPERATURE IN
PRE OPERATE MODE
Press:
The Display will show the last Product resistivity and temperature
values measured during DISPENSING mode or during
RECIRCULATION. The values are displayed for 5 seconds.
NOTE: The Product resistivity and temperature are displayed automatically during
DISPENSING mode or during RECIRCULATION.
5-5 HOW TO RECIRCULATE WATER MANUALLY BEFORE DISPENSING
This option is used to enhance the quality of the Product Water before dispensing water. The Booster
Pump will turn on and water will recirculate for up to 3 minutes. An auto-recirculation occurs for 3 minutes
every 2 hours.
Press:
The Display will show the Product resistivity and temperature.
NOTE: To dispense water, press the Dispensing Button during recirculation. Recirculation
will stop and water will be dispensed.
- 27 -
To Next Page
Loading...
