USING THE SYNERGY
DISPENSING
DISPENSING mode is displayed when Product
Water is being dispensed. DISPENSING mode
occurs because the Dispensing Button was pressed
down. The Booster Pump turns on.
The resistivity and temperature of the Product Water
is displayed during dispensing. The resistivity and
temperature remain displayed for up to 10 seconds
after dispensing is stopped.
A
UTO-DISPENSING
AUTO-DISPENSING mode is displayed when
selecting menu option F01. AUTO-DISPENSING
mode is used to dispense pre-set volumes of water
from the Synergy.
The amount of water dispensed and the resistivity
are shown while water is being dispensed. The
resistivity remains displayed for up to 10 seconds
after dispensing is stopped.
- 26 -
To Next Page
Loading...
