USING THE SYNERGY
HOW TO DISPENSE AN EXACT AMOUNT OF PRODUCT WATER (F01)
1. Press the Main and “-“
Buttons together to enter
the menu. The Display
will show F01.
2. Press the “+” or “-“
Button to adjust the
exact amount of
Product Water (in Litres)
needed. Pre-set
volumes of water can
be adjusted from 0.25
L to 9.75 L in 0.25
increments.
NOTE: The accuracy of this is dependent upon the accuracy of the Flow Calibration
performed in Section 4-9.
3. Press the Dispensing
Button once. The system
will dispense water.
The Display will show
the amount of water
dispensed and the
Product resistivity.
NOTE: To stop dispensing water, press the Dispensing Button once again.
- 23 -
To Next Page
Loading...
