MAINTENANCE
6-5 HOW TO REPLACE THE UV LAMP (UV SYSTEM ONLY)
The red UV Lamp Alarm will be blinking on the Display when it is time to exchange the UV Lamp. The
message is shown when the UV Timer has reached 0 days
(
see
Section 6-6 How to View or Reset the
UV Lamp Timer).
Open the front cover to go into STANDBY mode (A).
Unplug the electrical cord to power OFF the system (B).
No electrical power should be going to the
system at this time. Accidental exposure to
ultraviolet light can cause damage to the eyes
and skin.
HAZARD
!
A
B
C
Remove the Final Filter.
Remove the SynergyPak (C).
- 35 -
To Next Page
Loading...
