INSTALLATION
4-5 INSTALLATION OF THE TYGON TUBING
Locate the clear Tygon Tubing and the Barbed Fitting from the Accessories Bag.
Screw the Barbed Fitting onto the bottom end of the POU Dispenser (A).
Do not use any white tape on the threads of
the Barbed Fitting. An O-ring is located
inside the POU Dispenser to ensure water
tightness between the threads of the POU
Dispenser and the Barbed Fitting.
ATTENTION
Push one end of the Tygon Tubing onto the end of the Barbed Fitting (B). Place the other end of the
Tygon Tubing in a sink.
A
B
- 13 -
To Next Page
Loading...
