Using the Synergy R System
24
How to Dispense an Exact Amount of Product Water (F01)
1
Press the Main and “-“ Buttons together
to enter the menu. The Display will show
F01.
2
Press the “+” or “-“ Button to adjust the
exact amount of Product Water (in Litres)
needed. Pre-set volumes of water can be
adjusted from 0.25 L to 9.75 L in
0.25 increments.
The accuracy of this is dependent
upon the accuracy of the Flow
Calibration performed in Section
How to Calibrate the Flowrate from the
y R System (F02).
3
Press the Dispensing Button once. The
system will dispense water. The Display
will show the amount of water dispensed
and the Product resistivity.
To stop dispensing water, press the Dispensing Button once again.
4
To exit the menu, press and hold the Main
Button for 2 seconds.
To display the next menu option, press the
Main Button once.
To Next Page
Loading...
Need help?
General
