4 Installation, Operations & Maintenance Manual
Lifting
This manual should be used as a guide only - Follow your company’s recommended lifting
procedures. It is not intended to replace or take precedence over recommendations, policies
and procedures judged as safe due to the local environment than what is contained herein.
Use lifting equipment that is rated for the weight of the equipment to be lifted.
The personnel responsible for installing, operating and maintaining this equipment must become
acquainted with, assimilate and comply with the contents of this manual in order to:
• Avoid any possible risk to themselves or to third parties,
• Ensure the reliability of the equipment,
• Avoid any error or pollution due to incorrect operation.
Any servicing on this equipment must be carried out when it is stopped. Any accidental startup
must be prevented (either by locking the switch or removing the fuse on the power supply line).
A notice must be attached to the location of the switch to warn that servicing is being carried
out on the equipment.
During oil changing operations, the waste oil must be collected in a suitable receptacle. Any
overow of oil which may result must be removed using a degreasing agent suitable for the
operating conditions.
Soiled cleaning cloths must be stored in suitable receptacles. The oil, degreasing agent and
cleaning cloths must be stored in accordance with the rules on pollution.
Switch off the power supply as soon as any fault is detected during operation, such as over
heating or unusual noise.
Special care has to be taken for chemicals used in the process (acids, bases, oxiding/reducing
solutions, etc).
To Next Page
Loading...
