MIMAKI JV300-130 - Assembling the Stands and the Device

© 2014 MIMAKI ENGINEERING CO.,LTD. 4.2 P.3
R.1.0
1
2
3
4
5
6
7
INSTALLATION GUIDE > Printer Assembly > Assembling the Stands and the Device
Model JV300
Issue
2014.04.11
Revised F/W ver.
1.00
Remark
1.0
Rev.
4.2 Assembling the Stands and the Device
 Work procedures
1. Fix the right leg 2 to the right leg 1 with the 6 screws (M5x15).
Assemble the other side as the same.
2. Fix the leg stay to the leg with the 12 screws (M5x15).
3. Fix the roll guide BKT A/B to the leg with the 10 screws
(M5x15).
Right leg 1
Right leg 2
right : Red label
left : Blue label
Front side
Right leg 2Left leg 2
Front side
 Be sure to assemble, matching the color of the
labels attached on the leg1 and 2.
 Assemble the right leg 1 and left leg 1 correctly.
[Front view]
Left leg 1 Right leg 1
Leg stay
Leg stay
Temporary
tightening
 Temporarily fasten the upper screws on the rear
leg stay.
 Use the provided hexagonal wrench.
 For the tank tray, make sure that the tank tray is
assembled after the assembling of accessories is
completed. Otherwise, it may cause an injury by
catching a foot or so.
 Hold down the leg stay and fix it.
Direction to press
Direction to press
Roll guide BKT A
Roll guide BKT B
Roll guide BKT B
Roll guide BKT A
[TS model]
Roll guide BKT R
 When fixing the roll guide BKT, press it in the
direction of the arrow and tighten the screws.
Direction to press
Direction to press