MIMAKI JV300-130 - Unpacking

© 2014 MIMAKI ENGINEERING CO.,LTD. 4.1 P.2
R.1.1
1
2
3
4
5
6
7
INSTALLATION GUIDE > Printer Assembly > Unpacking
Model
JV300
Issue
2014.04.11
Revised 2014.05.08 F/W ver.
1.00
Remark
1.1
Rev.
4.1 Unpacking
 Work procedures
1. Remove the lid and sleeve of the box packing the main unit, cut
the tapes stuck on 4 corners of the main unit tray.
2. Take out each packing box.
3. Remove the leg stay packing assy.
Main unit tray
Tape
Sleeve
Lid
Lift up vertically
 Because of the small clearance between the main
unit and sleeve, lift the sleeve up vertically to
avoid touching the main unit.
Leg stay packing assy.
Metal sheet for
packing
Rubber feet
 Do not dispose the metal sheet for packing and
the rubber feet since these will be stored by
attaching to the main unit after the installation of
machine.