MIMAKI JV300-130 - Mounting the Accessories

© 2014 MIMAKI ENGINEERING CO.,LTD. 4.3 P.11
R.1.1
1
2
3
4
5
6
7
INSTALLATION GUIDE > Printer Assembly > Mounting the Accessories
Model JV300
Issue
2014.04.11
Revised 2014.05.08 F/W ver.
1.00
Remark
1.1
Rev.
4.3 Mounting the Accessories
 Work procedures
1. If the installation location is decided, lift up the main unit by the
stay, and put the lift-up block.
2. Remove the three screws each from the right and leftsides and
detach the Stay 1.
3. Disassemble the stay.
4. Fix the stay 2 to the screws (M5x15) being used on the stay.
5. Fix the tank tray to the right leg with the 2 screws (M5x15).
Lift-up block
 When putting the lift-up block, direct the front
and rear caster inwardly.
Inwardly
Stay 1
Stay 2
 After fixing the stay 2, fasten the screws which
are fastened temporarily in the procedure 2 of
[4.2 Assembling the Stands and the Device -P.3].
Tightening
Right leg
Tank tray